🔔 Please CLICK THE BELL if you wish to see my movies! 🔔
Get the OVERCLOCK3D AL-1775-3DB PACKAGE FOR 2007+ WRANGLERS over at https://www.kickyride.com/store/2007-jeep-wrangler-jk-only-plug-in-remote-start-alarm-kit/
Please watch the entire movies BEFORE YOU START your personal set up.
On this video we go contained in the Jeep, and I provide you with a fast tour of what I’m going to be tapping into below the sprint. I additionally provide you with some wiring updates and present you ways I be a part of and prolong wires, and in addition how I’m splicing into the wires which might be in present wire harnesses within the Jeep. I’m utilizing a army splice or army faucet. It is a very robust solderless connection that works nicely for these kinds of installs.
So that you need to set up an alarm system and distant begin into your Jeep Wrangler? Nicely… that is the web page for you! What follows beneath is the entire video sequence relating to the choice, overview, set up, setup, and howtos of the Omega Excalibur AL-1775-3DB safety system and distant begin I put in in my 2015 Jeep Wrangler with automated transmission. For those who occur to have the identical car (together with comparable years) then this web page must be a step-by-step information for you. In case you have a handbook transmission, there can be some extra steps and wiring for you, and what precisely is dependent upon what yr your Jeep is. I attempted to say a few of these issues all through the video sequence. In case you have a 2017 or newer, additionally be aware that the entry to the ignition change harness is a little bit totally different. I’ll additionally attempt to aid you on the market.
Please watch the entire movies BEFORE YOU START your personal set up. That is vital as a result of I’ll level out issues in later movies that may be useful to learn about early on. It’s simply a part of the method. As soon as I get into the set up, I do know extra about what precisely must be finished, versus what I consider must be finished. A fantastic instance of that is the wiring for the parking lights. Within the wiring prep video, I advised you that you simply wanted three wires for this as a result of that was the business customary primarily based on how the Jeeps have been wired. Nevertheless, in precise testing through the set up (and dealing carefully with the tech guys at Omega Analysis and Improvement) I discovered that just one wire was actually wanted. So I modified the harness from the unique 9 wires, right down to 7!! BONUS!!!