I will show you how to upgrade halton 1 by 12 Skala: 9205 e rc car, so let’s start. This is f40 4370kv brushless waterproof motor. This motor comes with 60 esc and program card. Dette er en 60 ampere esc. This is honor switch connected with the remote receiver and this is gyro, and for this you need three wire servo, so you have to change five wire servo to three wire servo and connect with the gyro. This is the old all its electronics. You see, this servo is a five wire servo and the receiver and connector ecs combo, and this one this old one and this is brushed motor 5. So i replace this all the things ecs and servo 5 wire to 3 wire. This is three wire servo. This is old esc and we have to change the remote too, because the old esc comes with the receiver, so this is flysky. Gt3B 2.4 gigahertz three channel remote with the receiver. This remote can be connect up to 10 device to use this mode. We need eight batteries, so that is very expensive and you have to change all the time or recharge the battery. This is on off switch and this is menu or you can adjustment your device so always no need to use the 8 Batterier. So i used the 3 cell 12 volt batteri 22 mh battery. So this is a very long life and you no need to change all the time.
Your bed, Okay, the motor size – is same. You can see this same size. Motor the pinion size is also same, so just remove the pinion. This is the screw. You have to open this screw, remove that cover and the pinion is same so just change the pinion to other motor to brushless motor that’s it. This is esc, and i show you how to by fixed that this is a fan, and this is waterproof. This is i fixed that with the velcro you can find anywhere any store. The this is the receiver for this remote and velcro double side velcro. This is sticky tape, and this is velcro and same thing. I i use the velcro at the esc. This is very easy. You can remove any time or replace or if something happens, just put the velcro both side – and i use this same thing with the gyro and this same velcro i use with the on off switch. So this is very easy to fix and you can remove any time to connect the servo and gyro is two wires once going to gyro to esc and other gyro2 servo. That is, that is very easy. Now all connection everything is fixed, so this is very easy to replace brush motor to brushless. I am using the new 1500 mah 60c battery, but you can use the stock one. It is all up to you: let’s check, it’s working or not just turn on the lights are blinking, this one’s all working the service working look, the gyro is how to work the gyro.
This is gyroscope. This is from this. You can adjust the sensitivity of gyro. This is full. You can adjust the sensitivity it’s all up to you to situation. I will use like a middle one. So Music always remember when you test like this, Vær forsigtig. It can be dangerous, so take care, you see all the working remove the car first gyro stable. The steering this is so all done now our car is brushed to brushless. Now this is new whole time, brushless rc car foreign Applause Music. What what now all done? So let’s go for this speed test.