Compustar FMX Remote Programming (Traditional Key)
Ersten, let’s identify the on and off positions on the ignition turn. Your key two notches to the on position. Your dashboard should light up when you do. This then turn your key back two notches to the lock or off position. Turn your key between these two positions. Five times within ten seconds to enter remote programming mode, leave it in the on position. If the LED on the antenna lights up, please tap the lock button. Once on your remote controller, the LED on the antenna should turn green to confirm the remote has been programmed. You can also confirm by pressing any command if the LED on the antenna doesn’t light up after the key cycling procedure. Press the button on the FMX antenna quickly tap the lock button on the remote four to five times until the LED on the antenna turns green.
[compare_prices_deals]
Quelle
![MINI RC DRIFT [ TSRACING RIMS ] #REVIEW #UNBOX [ LEGIERUNG ODER KUNSTSTOFF ]](https://www.rccars.guide/wp-content/uploads/2021/05/maxresdefault-156-236x133.jpg)
Ahh.. its remote start. Noice
Do these remotes work with older systems
I recently had the remote installed to my vehicle. Ich liebe es. However I cannot figure out how to get it to unlock all doors as opposed to just the driver door. Is there a certain number of times to press unlock or a certain amount of time. I did get them to unlock once but cannot replicate what action unlocked them. Danke!