It was quite a process. Stiff paper to hand formed aluminum sheet welding, all the good stuff. The first test drive went pretty well, but i didn’t want to crash. I need the body for the vacuum forming buck Applause with the body. Pretty much done, i used plaster to make the bottom of the buck. I also needed to fill in other areas of the body. The heat box is cardboard and aluminum foil. I used an infrared patio heater and built a steel frame to hold the plastic sheet. The platen is made out of mdf, stair tread, i drilled inch and a quarter holes for the vacuum hoses and a piece of perforated steel sheet supports the plastic. During the pole. The 1500 watt heater works well heating, the plastic quickly i’m. Turning this on is your the camera rolling yeah, the camera’s rolling heat’s on timer is about 10 minutes till it’s glowing. How long does it take? I don’t know it could take as little as five minutes. It could take as long as fifteen okay, so we know that you’re going to say, go yeah right when you want me to start so i’ll be over there. Applause, don’t yep! This is not Applause.