Won’t work. 2005 Impala. On the step where you put switch on and off it does not activate the door locks. Rispondi
Won’t work. 2005 Impala. On the step where you put switch on and off it does not activate the door locks.
Thanks again sir I program my truck for the second time. Make sure you guys get the alarm controlle for your vehicle name, brand and year 🤙
Mine didn’t work after doing this, it was working good and then just stopped working.
Good instructions. My drivers side door controls don't work anymore so I had to use passenger door unlock button to program. Works great. Grazie.
I did it while I watching the video at the very first try
Thanks from http://www.MiniBullTerrier.Org
Ottimo video. Short, sweet, and to the point. Grazie!
Ok…I have a Cavalier with standard transmission. There's a little button on the steering column to help remove the key. The button gets stuck at times and I can't complete they cycle. Even if I can, the recycling process won't work. I've followed the instructions on this video to the T, and it's not working.
I got these from Amazon a few years back, and the battery fit in them is awful, but since I'm unable to do the recycling, I'm SOL! Any suggestions would be appreciated.
Worked as described in the video, Grazie!
Grazie , worked on 03 GMC Yukon on the third try , I dunno y it worked but it did work 👍
Very good information, It was very easy..
It’s not working for my 2000 Silverado… am I doing something wrong?
Worked for me. Nice to have extra remotes working. Grazie
For some stupid reason this ain't working for me. '01 GMC. It won't even go into the 'programming mode '
Thank you sir great video 👍
Didn't work on my 02 yukon
Awesome video thanks!!
I couldnt figure out what i was doing wrong… Programming separately,.. Good thing I watched your vid.
Ottima spiegazione, simply put. Thanks much
Worked for me!
I've watched his video several times because I buy and resale these truck I hope you have earned a lot of money from YouTube thank you sir
I try this on my 2006 GMC Sierra goes into programming mode but before I could hold both buttons down its get off programming mode someone help please