Go to us at http://www.carandtruckremotes.com/

PLEASE READ CAREFULLY BEFORE TRYING! IF AT ANY TIME YOU MAKE A MISTAKE, START AND STOP YOUR CAR, EXIT THE VEHICLE AND START OVER. THE REMOTE CAN BE ONLY PROGRAMMED WITH A MASTER KEY

1.SIT IN FRONTIER WITH DOORS AND WINDOWS CLOSED.

2.LOCK DOORS WITH POWER DOOR LOCK SWITCH ON DRIVER’S DOOR.

3.PUT IN AND PULL OUT FRONTIER KEY FROM IGNITION APPROX. eight TIMES OR UNTIL YOU SEE THE HAZARD/TURN SIGNAL LIGHTS FLASH.(older fashions lights could flash after Four or 5 occasions) YOU NEED TO DO THAT IN LESS THEN 10 SEC

4.WHEN HAZARD LIGHTS FLASH (ON 2005 AND NEWER MODELS THE GAUGE NEEDLES MAY JUMP A LITTLE INSTEAD) , PUT KEY IN IGNITION AND TURN TO THE ACC POSITION.(when your hazard lights flash your automotive is sending a sign to be obtained by the distant)

5.PRESS FRONTIER LOCK BUTTON ON THE NEW REMOTE TRANSMITTER, LIGHTS SHOULD FLASH AGAIN.

IF YOU HAVE 2 REMOTES, 1 NEW AND 1 OLD OR 2 NEW ONES, PLEASE CONTINUE WITH STEPS 6 AND 7. IF NOT, SKIP TO END.

6.PRESS FRONTIER UNLOCK BUTTON ON DRIVER’S DOOR, THEN LOCK BUTTON ON DRIVERS DOOR, LIGHTS WILL AGAIN FLASH

7.PRESS LOCK BUTTON ON 2ND NEW OR OLD REMOTE. LIGHTS AGAIN WILL FLASH.

YOU ARE DONE. EXIT VEHICLE AND TRY YOUR REMOTE. IT WILL NOT WORK FROM INSIDE CAR OR WITH KEY IN IGNITION.

Notice: in case your hazard lights flash after inserting your key out and in, however you may’t get the distant to program, you could have a useless battery or the flawed distant. If directions don’t work, do it once more however if you get in – shut the door, buckle seat belt and lock doorways, then proceed to placing key in ignition

[compare_prices_deals]

source