You’Ll find one RC vehicle, a pup pad controller and an instruction sheet to get your paw patrol on a roll you’ll need to connect. The pup pack controller first use a screwdriver to open the battery doors and place three Triple A batteries in the vehicle and do triple a batteries in the controller, then turn the vehicle and pup pad on by sliding each of their power switches to the on position. Possum now we’re ready for action saving the day in Adventure Bay is super easy with the easy to use, pup pad press and hold the left button to drive forward and press the right button to reverse and turn that’s it for the best rescues drive indoors. On hardwood floors, tile or other low trim surfaces and always avoid water or wet areas. If your RC vehicle isn’t driving, try Lea connecting the controller to the vehicle to do this by the power switch on both the vehicle and remote to the off position and then turn them both back on always make sure you’re using fresh batteries. If chaser Marshall pop out of your vehicle during a rescue, you can easily pop them back into place.