10 YEARS OLD Nitro RC Car from eBay! | WILL IT START? | Upgrading Radio System
If you haven’t already subscribed, please make sure you hit that red subscribe button down below and hit the notification bell see you can see more RC videos coming soon and also the motorbike content as well, which will get going a little bit more when we’re allowed out The house again so in this video we’re going to be looking at this buggy one of the two buggies that I bought from eBay. I paid ninety pounds for this buggy it’s, a very nice quality, powozik, a cotton, but the name of X, I’m still out and about but you’ll see the name of it in the title down below. If not the comments section as well. So in this video we’re just going to be setting the buggy up I’m going to be changing the FM transmitter for a 2.4 system gigahercowy, I’m going to test out the electronics in the servos and then I’m, hopefully going to start up the engine for a very First time and I’m just going to show you how I would approach starting up an engine, I know nothing about. I don’t know how it’s been tuned. I don’t know how it’s been running. I don’t even know if it runs at all, but it does have good compression. So I don’t see any reason why it wouldn’t so let’s make a start, and I need to first I’m going to grab the stock radio system and I’m just going to see if the servos and everything yes, the standard, radio that was included in this – and I Think this just gives you an idea as to sort of how old this vehicle is.
Oczywiście, we don’t know that this transmitter is the original one, but I suspect it probably is because everything else about the car is is standard. Wierzę, że, with the exception of the custom body shell, so I think this cars about 10 years old and don’t get me wrong. Jest, nothing wrong with continuing to use these FM. Radio, Tak myślę, is FM radio it’s, nothing wrong with continuing to use them, but I’ve got lots of 2.4 jira Seavers kicking around that I might as well. You know rehome into cars that I’m going to be using. So there’s no real reason to continue using it but I’m, just gon na start by checking that the the electronics works and we turn the transmitter on turn on the receiver I’m. Just gon na check the throttle. That seems to be opening and closing perfectly fine and then let’s check the steering as well snugly. So we know now that the electronics work – and I just wanted to check that before I change the receiver just so that I know that it works. A potem, if there’s an issue – and I put the new receiver and I know it’s something wrong with the new receiver as opposed to wrong with the electronics, so I’m gon na go, find a receiver pop it in this one and check it on 2.4 G. Więc, just looking at the collection, I’m going to nab a receiver out of one of these cars down here, don’t know if that one’s got one in.
I know this one has not likely to be using that little shortcut short course truck for a while and so I’m going to nab the 2.40 sivir out of there and install it into. I was gon na have this receiver, but seems that the antenna has been chopped off, so I won’t be using this one: let’s try and source another okay good. So just found myself, 2.4 gigahertz radio FS GT 2 Odbiornik. These receivers, I pay four pounds each for these on she’s really really good, find plug as well, because we’re cause need to bind the receiver to this transmitter. These transmitters, you can bind to multiple receivers at once. So generally, I just use one receiver because it changes their saves on the batteries. You know so I’m going to go ahead and install it into the color okay. A couple of those disappointed that ran into the receiver now upgraded to much more reliable 2.4 gigahertz transmitter system well worth upgrading is still running an FM radio, I’d say number one upgrade you guys could do few cars just replace it with a nice. Two points: 4G. Radio setup so I’m just going to pop this back into the case and then we’ll move on to the next thing, which is draining out the old film and then getting the engine started, and I thought at the same time let’s replace the four a battery pack. Where the hate behind plasma, six volt, humpback, sorted okay, so receiver now installed it’s running on 2.
4 G, just also replace the full AAA batteries with a 6 volt Compaq, just old up the air filter as well.
[compare_prices_deals]
Źródła
Morning Everybody! Since the editing of this video it has transpired that this car is a Reely Rex X Rather than the XTM X Terminator. Both cars are very similar though!
Hope you're all well and got an RC Adventure planned for this sunny weekend.
Amazon Wish List Link —–> https://tinyurl.com/yahlhys2
Another video tomorrow @ 9am !
Hey how's it going? You are one of the reasons why I switched to nitro from brushless!
Bloody ell great start ..
awesome vids, thanks for all the help. just revisited my savage xl 5.9 po 5 Lat. fired right up, what a beast. i forgot how addictive this hobby/sport is!
Hey thanks for the reply and to answer your question it is blowing the flywheel inside the transmission that grabs or what not when the slipper clutch is engaged. And my main question is I've never been able to get it to tune right I almost always needed to run it with the low speed almost always closed is this because the clutch has probably almost always been bad. I did get it to do 33.24 mph tho.
Have u got any info on my hsp 1/10 scale monster truck it’s an sh engine
Hey I would love some advice I have redcat nitro 3.5 and it has destroyed 2 transmissions and now the clutch has failed. The transmission is particularly throwning fly wheels so it won't shift to second or it jus strait revs and won't go what am I doing wrong cuz my cars idle fine
I respect what you are doing. I have nitro cars that haven't run in well over 20 Lat. Any one of them will start right up. Put on a new air filter and fuel it up. Storing it with a clean tank is always smart. My big "secret" is to use a good after run oil, then I store the car wrapped in Saran Wrap after a full and proper cleaning. Never had a car that would not start right up. Every now and then an engine will get a bit stiff. Simply take the engine apart and clean/lube it well. You got a great deal . Nicely done video. Started right up! That car is good for a lot of future runs man.
To jest niesamowite
Of course she started right up! That's a force .21 engine ..they had those in hpi, ofna, and a few other brands for years …I run one in my Hpi Hellfire …more mid-range power than most the cheap RTR .28 engines they put out now …
Nice mate!
Nice bro watched ads for u
I really dig vintage CONTROLLERS… My classic RC that I want is a OFNA ULTRA LX 1/8 with a picco .28 bwaaaa bwaaa!!
Its defo a gv rex x I have one with the same remote only thing different on mine is the wheels 😀
Ładne, no drama there.
It’s great to see an RC channel which features nitros at the the fore front, nowt like the smell and sound of a glow engine in the morning…😆👍
Looks like it’s in great condition. Love nitro and love your videos 👍👍👍
It will start if it has good compression fuel and good glow from glow plug
Nitro gang
Make your videos longer bro really enjoy watching your videos
Hey buddy. I've been watching your videos for years. Wanna hear something funny? On one of your early videos when you were a kid I told my dad who was watching with me that you were 50 years old and had a condition that kept you young. He believed me for about 30 seconds hahaha. Good man for all the Nitro RC info. Glad you're back
I feel like I have grown up with you, followed you for so many years, its awesome to see you still enjoy messing with nitro as I know they can be quite a hobby!
Also what brand of fuel do you use?
0:20
sweet-girls.online
Sounds healthy,if I've ever had a problem with a nitro car that's been stood it's been caused by perished rubber seals in the carb or end cap,but as you know,there isn't much too go wrong otherwise.✌👍
HLO TOAOT
2Nd – Very nice video mate!! Look forward to seeing that rip – got to love 8th scale buggy
1St