This is a small miniature tank guesting or you can use it as compressor tank or any water tank for your miniature car or your rc car, just as for an accessories protocol Music. So what you’re gon na need is a bottle for this i’m using a refill bottle, it’s a refill liquid for e cigarettes. This is a pen, so you’re gon na need the pen only the body two round, aluminium or cardboard with the size of the bottom. Two piece: you need one, eight millimeter diameter of washer and you need a super glue, a hot glue and a tape, aluminium tape. Okay, before we start, please do share and subscribe my channel. Thank you all right. Let’S begin. Okay, first of all, you must clean it. Try it make sure there’s, no sticky things and chop the top off. We don’t need this part only on we’re gon na use. Only this part, all right, then drill a hole with the size of this pen, the size of this pen and i’m gon na use. It as the inlet for the gas tank, you can actually drill anywhere side top center anyway it’s up to you right to speed things up. I made one for you. This is the thing this is the tip of the pen right for the tip i’m gon na. Do this first, you need this aluminium tip cut into somewhere around 1 cm peel. It off be careful, while you’re using sharp object, tape around the pen, all right, Music and you’re gon na stick this at the top to stick.
It you’ve got to use a hot glue, pen, hot glue, gun. Sorry, not really good english, just stick it and let it add it: okay for the bottle cut a square unit, two peel it off take the aluminium or your cut. Your dick paper or cardboard previously cut and cover the bottom just press around no need to fold it because we’re gon na cut it use the scissors to cut all the aluminum around here. Right then put it down for the other side you you can cut it roughly, so you can no problem, make sure everything is centered all right. Okay, for this part, i’m gon na need to measure the bottle and cut half centimeter extra one more similar. The other way around don’t worry about the wrinkles. It will go out then, okay, excess on this side and take your tank and roll it over the edge same goes the other side that’s the base of aluminium. If it’s wrinkled just push it all right for the hole just make a hole here previously, you cut, take the tip, take the tip and you slide it in so all right. I have taken off this washer i’m improvising it and to look more realistic. Put a screw here, fill up the hole with glue, take the screw and push it in all right, that’s it. This is just for me for demo. You can make it more versatile or make it more nicely, do a proper wrapping, proper gluing or you can change the washer to a hex nut to resemble the gas tank cap it’s up to you, then you can mount your gas tank onto your car and fix A bracket or you can use a cable tie and mount to your body all right, so i think that’s all don’t forget to subscribe.