So once you have pace out the length of the bungee, you have to double that pace and that’s going to be the stretch you’re going to need to pull for having a double extension of that rubber. So we’re going to put the stake. Double the steps you have made just for the bungee, so you have two steel rings and the quick release. So you just remove the quick release and now you’re gon na be pacing double, and this is basically where the second state is gon na, be so on that second stage just put the screw in and the tension, the orientation of the tension you need to have More or less a steel ring pointing here mel off that quick release. So when you, when you look at that, you’re gon na need to point about straight, not having it straight this way, but slightly slanted and same thing. We’Re gon na be putting it about 20 degree. Angle, it’s very important because, if you’re, if the ring is just here just here, it’s not going to release so you need, you need the pressure to be in the middle of that part, and it will quickly release everything grinding that down. You need a mallet Music controlling where the pin is going so i’m checking that i’m at the right angle and going about as flush as i can. So if your wheel is going over, it it’s not going to stop the glide.
So now just put the line inside the hole go over it, and here you go so i’m, just putting it without tension, the first of the rings, the second one will.