I welcome you here in my little rc garage thanks for watching this. The excellent gearbox on the new teammate buffalo are finished and the next steps are building the links and tempers step. 26 is the build of the front upper links, the correct ball connectors and how these have to be installed, as shown in the manual first, i turn in the socket screw on the ball connector. Then i use a bit of thread lock and screw on the link. Music it’s the same on the other side. Now i have to press in the ball heads and the first link is done. Step 27 is the build of the front, lower links to be sure to use the correct links here is a full size drawer in the manual so it’s easy to find it and also here, be sure to use the right connectors in the correct orientation. And here are these links. I made it on the same way as the first ones. Step 28 are the rear upper links and, as you can see, i have already finished it. Music step 29. Are the rear, lower links? Step 30 is the panhard bar Music step? 31 are the steering rods, and here you can see all the links and steering rods are finished as next we start with the dampers step. 32 is to add a rubber o ring to the damper cap. Music, be sure it sits on the correct position. Step 33 is the assembly of the damper, pistons and cylinders included are three different pistons with two three or four holes: asmr holes, the piece in half the damper getting softer the manual says to install the three holes piston so i’m.
Going this way the piston have to be secured with an e clip Music on the bottom of the cylinder. I add a bit of damper oil and insert the rubber o rings and Music spacers. I can close the cylinder at the bottom Music. Next, i insert the piston into the cylinder step. 34 is to fill the dampers with oil. First, i fill the cylinder a bit more as half and move the piston slowly up and down to remove all air bubbles. Then i fill it completely and move the piston to the top. Now i can close the cylinder cap wipe off excess oil Music, but now the damper cannot be fully compressed that’s because too much oil is inside. So i remove the cap again and take out a bit of oil Music, and now the damper works better smooth and it moves the full way. Step 35 is the completion of the dampers first turn in the adjustment ring on the top. With this ring, the spring preload can be adjusted, then add the ball connector on the piston rod installing the spring and the ball head on the connector, Music and the dampers are finished. Now this is it for the moment. The next step is to bring all these parts together and build the chassis stay tuned. To see this subscribe to my channel, you haven’t already, and please give me a thumbs up for this video.