8 G remote control system. This is the DJI 5.8 G remote control system step one remove the propellers step to uncover the stickers and arms step 3. Remove the screws note keep the magnetic screwdriver away from the compass module on the landing skid step 4. Remove the upper shell and unplug the GPS cable step 5 unplug, the original 2.4 G receiver servo cable, Шаг 6. Remove the receiver set screws, Шаг 7 cut the nylon, cable ties and take out the antenna. Receiver unmounting is complete on the left side. Is the 2.4 ghz burr on the right side? Is the 5.8 g receiver next mount the 5.8 g receiver on the phantom to fasten the 5.8 g receiver module tighten the antenna with some nylon cable ties thread the antenna through the preformed hole and secure it unplug the exp cable to easily connect the receiver plug The X one servo cable into the right side mount plug the X two servo cable into the left side. Mount then plug the exp cable to complete the 5.8 GA receiver mounting. Now we will mount the light bridge. This is the gimbal cable connect it to the reserved exp port on the central board thread: the cable through the preformed hole on the phantom 2 to connect to the air system, plug the GPS, cable back in and remount the upper shell for the light bridge air System connection, please refer to the light bridge installation demonstration next demo, Teh 5.
8 g control link and 2.4 g image link turn on the 5.8 g remote control power up the phantom 2 five point: eight G, пульт дистанционного управления, demo, motor spinning control, five point: eight G, remote Control demo, gimbal tilt control, connect your smartphone or tablet to the light bridge ground system press once to check the battery power hold for two seconds or longer to power up the system run the Lightbridge app 2.4 g image data transmission demo.