So you don’t miss when i do an unboxing and review on this dumbo rc transmitter and receiver combo. So here is the typhon exb that we are going to be installing the wing mount on today. Uh first thing: you’re going to want to do is make sure you have the the screw down here for this rear chassis, brace loosened up there’s, a pin that goes through this. This back uh hole in the chassis brace, so you’re gon na wan na make sure you have that loosened up. So here are all the parts and pieces that come with the uh wing mount kit for the armor typhoon. I’Ll link that part number in the description. As well, these standoffs here normally would go. You would attach them to your wing, but this part didn’t break off when i crashed the truck so i’m just going to leave those on there for now i’m going to get the wing assembled on the bench here and then transfer the whole assembly onto the truck Music Music, so once you get this wing fully assembled on the bench uh now you can go ahead and throw in the truck and i’m sure it would make my life a little bit easier if i removed these two body posts back here, but i am not Going to do it just because i want to get this done so what the best way to do. What i found is kind of squeeze on these mounts a little bit to get them to go in the holes on the shock tower and then once you get it in there, you can kind of push them down into place.
While you pull the wing mount inward. 好, so now i’m going to grab this hardware, i left it attached to my old broken wing mount just so i knew which pin went where and which spacer went where as well. So what you’re going to want to do guys is put these nuts in the wing mount before you. Try and put the the pins in so i’ll. Show you there’s these little holes right here where the nuts go and it’s easier to do it it’s much easier to do it before you get it in the truck or before uh you go to put the set pins in at least so once you get your Pins ran through both the chassis brace spacers and the standoff from your diff case. The next step is going to be install two screws back here on the back of the wing mount they go through the shock tower and attach to the front side of the diff case. The truck normally comes with these cap head style, screws, 他们是, 3 by 20. Millimeter i’m, replacing them with some three by twenty millimeter button head stainless steel screws, alright guys. So there is your how to on attaching a wing mount on a typhon 6s, so you’re ready to rip all right guys thanks for watching, 如果你喜欢, the video make sure you hit that thumbs up and if you like me make sure you subscribe.